“Bipie” build thread

Marking control rod length

Marking CF push rod to cut to length

Marking CF push rod to cut to length

Since I’m using the UMX Gee Bee brick, I’m limited to very thin wire for the push rods. This wire is way to thin and flexes way too much when run all the way back to the rudder and elevator. I fashioned new push rods from 0.040″ CF rod, 1/16″ shrink tubing, and CA. The first step was to cut the CF rod to length.

Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *